Phottix Laso TTL Flash Trigger vastuvõtja(Canon)

119,00 €

Uus

Phottix Laso välgu vastuvõtja (reciver). Võimaldab koos Laso transmitteriga kontrollida neid Canoni välke, millel ei ole sisse ehitatud raadiovastuvõtjat. Toetab HSS (High Speed Sync) kuni säriajani 1/8000 ning Elinchrom stuudiovälkudega HSS režiimis töötamist.

Garantii 2 aastat.

Rohkem infot

Rohkem infot

Introducing the Phottix Laso TTL Flash Trigger. The Phottix Laso Flash Trigger System allows users to control and trigger Canon radio-enabled flashes, as well as control and trigger Canon’s non-radio flashes mounted on Laso Receivers. Using Phottix Laso Receivers, photographers can control and trigger older Canon flashes without built-in radio functions. Studio lights can also be triggered by the Laso Receiver, adding a new layer of creativity.

 

Features

  • 15 channels with Digital ID
  • AF Assist Light
  • High Speed Sync1/ 8000**
  • Support Multiple Flash Modes including ETTL II/ ETTL, Manual, Multi, Ext.A and Linked Shooting***
  • Controls and Triggers Canon-compatible radio-enabled flash****

  

Laso Transmitter

The Phottix Laso Transmitter can control and trigger 5 groups* (15 units) of Canon-compatible radio-enabled flashes and supports multiple flash modes, including ETTL II/ETTL, Manual, Multi, Ext.A and Linked Shooting.

 

Laso Receiver

The Laso Receiver works with Canon’s nonradio ETTL flashes. Users can control and trigger these flashes from different radio devices, including the Phottix Laso Transmitter, Canon ST-E3-RT flash transmitter, and Canon radio-enabled flashes. The Laso Receiver can also be connected to studio lights, offering the ability to mix hot shoe flashes and studio lights in one triggering system.

  

Please note: Product specifications and external design are subject to change without notice.
* On compatible (Canon) cameras released after 2012 (excluding EOS1200D).
**ETTL auto flash is not available with EOS film cameras and EOS 1D, EOS 1Ds.
***Multi flash is not compatible with Laso receiver.
****Group flash is not possible with cameras released before and up to 2011 (and EOS1200D), flash sync speed will be one stop slower than normal sync speed.

Compatible modelsEOS type-A camera compatible with E-TTL II/E-TTL autoash**
Dimensions84.1×68.3×58.5 mm
Weight118 gExcluding the batteries
ChannelAuto, Ch.1-15
FEC (Flash exposure compensation)±3 stops in 1/3- or 1/2- stop increments
Power savingAuto Idle if not operated for 5 min
Range100m
Frequency2.4 GHz
Power source2 x AA alkaline batteries or AA NI-MH batteries
High Speed And Second Curtain Sync1/8000s* , high speed sync is possible only with EOS digital cameras released since 2012
TypeOn-camera wireless ash trigger
AF Assist LightYes. The AF assist beam is eective within 5m range (lens zoom range 17-105mm) measured from the center AF point.
Exposure Control SystemE-TTL II/E-TTL auto, manual ash, multi. flash, auto external ash metering (only when the ash mode is set to )***
Manual Flash1/1-1/1281/3-stop increments
Flash Ratio Control1:8-1:1-8:1, 1/2-stop increments
Modulation SystemPrimary Modulation: OQPSK, Secondary Modulation: DS-SS
Wireless Radio ID0000-9999
Slave Unit ControlUp to 5 groupsA/B/C/D/E****, up to 15 units

Please note: Product specications and external design are subject to change without notice.
* On compatible (Canon) cameras released after 2012 (excluding EOS1200D).
**ETTL auto flash is not available with EOS film cameras and EOS 1D, EOS 1Ds.
***Multi flash is not compatible with Laso receiver.
****Group flash is not possible with cameras released before and up to 2011 (and EOS1200D), flash sync speed will be one stop slower than normal sync speed.

Seonduvad tooted

30 toodet samas kategoorias